Utilize este identificador para referenciar este registo: http://hdl.handle.net/10400.9/2656
Título: Hot treatment and upgrading of syngas obtained by co-gasification of coal and wastes
Autor: Pinto, Filomena
André, Rui Neto
Carolino, Carlos
Miranda, Miguel
Palavras-chave: Biomass
Wastes
Coal
Co-gasification
Sulphur compounds
Nitrogen compounds
Data: 2014
Editora: Elsevier
Citação: Pinto, F.; André, Rui N.; Carolino, C.; Miranda, M. - Hot treatment and upgrading of syngas obtained by co-gasification of coal and wastes. In: Fuel Processing Technology, 2014, Vol. 126, p. 19-29
Resumo: Nowadays there is a great interest in producing energy through co-gasification of low grade coals and waste blends to increase the use of alternative feedstocks with low prices. The experimental results showed that the viability of co-gasification to process such blends and that by the right manipulation of coal and biomass or waste blends, syngas treatment and upgrading may be simplified and the cost of the overall process may be reduced. Blends of three different coal grades (sub-bituminous coal from Puertollano mines, South African bituminous coal and German brown coal) with two different types of biomass (pine and olive oil bagasse) or polyethylene (PE) were co-gasified. Blend co-gasification showed to be beneficial to reduce the negative characteristics of some coals, such as the high ash and sulphur contents, especially of Puertollano coal. Syngas obtained by these blends was hot cleaned and undesirable syngas components (tar, NH3 and H2S) were measured along the hot treatment tested, which proved to be suitable to treat syngas produced by a wide range of feedstocks. Different routes for syngas cleaning were analysed to reduce unsuitable components to values required by most common end-uses. The results obtained showed that the type of feedstock to be gasified is a key outcome on initial syngas composition, affecting greatly syngas cleaning needs, its application and the economic viability of the overall process.
URI: http://hdl.handle.net/10400.9/2656
ISSN: 0378-3820
Versão do Editor: http://dx.doi.org/10.1016/j.fuproc.2014.04.016
Aparece nas colecções:UB - Artigos em revistas internacionais

Ficheiros deste registo:
Ficheiro Descrição TamanhoFormato 
FuelProcessingTechnology_Vol.126_19.pdf139,55 kBAdobe PDFVer/Abrir


FacebookTwitterDeliciousLinkedInDiggGoogle BookmarksMySpace
Formato BibTex MendeleyEndnote Degois 

Todos os registos no repositório estão protegidos por leis de copyright, com todos os direitos reservados.