ME - Comunicações em actas de encontros científicos internacionais
URI permanente para esta coleção:
Navegar
Percorrer ME - Comunicações em actas de encontros científicos internacionais por Objetivos de Desenvolvimento Sustentável (ODS) "09:Indústria, Inovação e Infraestruturas"
A mostrar 1 - 3 de 3
Resultados por página
Opções de ordenação
- Dielectric UV filters for protection of fire-resistant glass based on intumescent layersPublication . Silva, Ricardo Magno Lopes; Hashim, Hurraira; Roy, Deepto; Oliveira Fernandes, Carolina; Oliveira, Kevin; Leitão Pinheiro, Xavier Alexandre; Esteves, M. Alexandra; Capelo, Anabela; Donato, Mariana; Oliveira, Fernando; Ferreira, Cristina; Alves, Isabel N.; Cunha Diamantino, Teresa; Barreiros, Maria Alexandra; Rocha, Jorge; Passos Teixeira, Jennifer; Salomé, PedroABSTRACT: Structures such as OLEDs, perovskite solar cells, intumescent glasses, and other components in modern devices and buildings contain materials suscep-tible to degradation when exposed to UV radiation, requiring protection to with-stand outdoor environmental conditions. In this work, multilayer coating config-ured as a Bragg Reflector on glass is employed as spectral filtering to protect the intumescent component of fire-resistant glass from degradation due to prolonged UV solar radiation exposure. By alternating low-n (SiO2)/high-n (TiO2) dielectric layers through spin-coating, precise control over film thickness could be achieved, allowing the fabrication of thin (<700 nm) UV filters with high trans-mission of visible sunlight – 88% of the 780 to 380 nm wavelength range – while reflecting almost all the incident UV – 90% of the wavelength below 380nm. Using relatively simple techniques, high precision coating was successfully achieved, resulting in an effective UV radiation protective barrier applied to en-hance the durability of the components in fire-resistant glass.
- NEWS4CSP Project: New Coatings Approaches to Protect Metallic Materials From Heat Transfer FluidsPublication . Cunha Diamantino, Teresa; Pedrosa, Fátima; Paiva Luís, Teresa; Ferreira da Silva, Eduardo; Gonçalves, Francisco; Monteiro, Renato; Cardoso, JoãoABSTRACT: The efficiency of Concentrated Solar Power technologies increases with the opera-tion temperature of the power block, which can be achieved using advanced power cycles operating at temperatures ≥650°C. Molten Salt (MS) based HTF have been facing critical chal-lenging issues of severe corrosion and lower specific heat capacity. This paper aims to present the NEWS4CSP project to the CSP scientific community, highlighting the main concepts being pursued and the preliminary results obtained regarding the application of new coatings to in-crease the anticorrosive protection of structural materials in contact with MS. Two different types of powder coatings (nickel and cobalt alloys) were applied to AISI 430 stainless steel using two coating technologies: High Velocity Oxy-Fuel (HVOF) and Laser Cladding (LC). LC proved to be the most suitable technique of these two coating application technologies. The Co-Cr coating alloy showed good anticorrosive behaviour even after 3000 h of testing. The obtained results are very promising, nevertheless, more studies are needed to optimise its application by LC. These include optimizing the thickness and chemical composition, as well as gaining a deeper understanding of the degradation mechanisms and whether this behaviour is maintained over longer periods.
- Protection of Steel Structures against Fire and Corrosion by Paint Coatings: A comparative studyPublication . Ferreira, Cristina; Gonçalves, Rita; Alves, Isabel N.; Vieira, Ana; Donato, Mariana; Morgado, Vanessa; Silva, Helena; Cristino, Ana Filipa Russo de Albuquerque; Nunes Soares, Tiago Diogo; Barreiros, Maria Alexandra; Cunha Diamantino, TeresaABSTRACT: Steel structural systems in modular construction must be protected against corrosion and fire exposure. The durability of both protective properties plays a key role in ensuring long-term service life and minimizing maintenance costs. The present work aims to validate anticorrosive protection systems for steel structures, with and without fire protection properties, evaluating degradation mechanisms and assessing the compatibility of intumescent layers with anticor-rosive coatings, in terms of their impact on corrosion resistance and fire protec-tion properties.